PcChips
M507
by A.C. (since 23/08/2000) http://acc.hop.to |
Avviso |
Disclaimer |
BWZ Analysis |
|
Program | Unicore BIOS Wizard Version 1.5 |
BIOS Date | a) 07/31/95 b) 03/12/96 c) 03/11/96 d) 04/10/97 |
BIOS Type | Award Modular BIOS v4.50G |
BIOS ID | a) 07/31/95-TRITON-2A59CF54C-00 b) 03/12/96-i430FX-2A59CF54C-00 c) 03/11/96-i430FX-2A59CF5HC-00 d) 04/10/97-i430FX-2A59CF5HC-00 |
OEM SIGNON(Bios Eval) | a) Release 09/01/1995 b) Release 03/11/1996 c) 03/12/1996 RELEASE d) PM7600 Release 04/10/1997S |
Chipset | Intel Triton 430FX rev 2 |
Superio | UMC 8663A rev 0 found at port 108h |
Direct Analysis |
|
Manufacturer | Fugutech (Pc-Chips) |
Model | M507 (equal to Amptron PM-7600 , (see note // guarda la nota ) ) |
Subversions | M507 Large Block Size Bios ("L" label) |
M507 Small Block Size Bios ("S" label) | |
Chipset | Intel Triton 430FX |
Cpu | P54C, P55C (mmx) optional Pentium 75-200 MHz , (see note // guarda la nota ) *Questa mainboard supporta tutte le cpu a singolo voltaggio (V-I/O = V-Core ). Tali cpu sono : Amd K5, IDT Winchip C6/W2/W2A ed alcune cpu Cyrix della serie 6x86. La cpu piu' veloce che si puo' installare senza modifiche hardware , adattatori, o VRM opzionali , e' l' IDT W2A 233MHz. *This board supports all single voltage CPUs. These are the intel Pentiums, AMD K5, IDT C6/W2/W2A and some early Cyrix 6x86 CPUs. The fastest you can put in without hardware modification, adapter sockets or a VRM, is an IDT W2A 233 MHz. |
Optional VRM Socket | *Usando un VRM (Voltage Regulator Module) opzionale,
questa mainboard puo' supportare le cpu con doppia
alimentazione (V-Core diversa da V-I/O), ma in alcuni
modelli il socket in cui inserire il VRM e' assente . *With an additional VRM, this mainboard can support mmx cpus, but in some models this socket is substitutes by a solder pads! |
Cpu Voltage | 3.3, 3.5V |
Bus Clock | 50, 55, 60, 66MHz |
Multipliers | 1.5x, 2x, 2.5x, 3x |
Socket | 7 |
Cache | 256, 512 KB asynchronous DRAM, or 256 KB syncronous DRAM ( Intel COAST standard 256KB/512KB Pipeline Burst or Asynchronous SRAM modules) |
Bios |
|
Memory | Up to 128MB Main Memory Four 72-pin SIMM slots for EDO and Fast Page Mode DRAM Modules |
Dimm | none |
Simm | 4 |
Pci slot | 3 |
Isa slot | 4 |
Agp | none |
PS/2 | *NO: Il chips di Multi I/O UMC 8663
ha un bug che non consente l'uso di una tastiera e di un
mouse PS/2 contemporaneamente * No : UMC 8663 Multi I/O has a bug, which prevents the use of the keyboard AND the mouse at the same time |
Usb | no |
SCSI NCR810 Support | yes |
I/O | Two PCI Enhanced IDE Ports Supports 4 Devices PIO 0-4 with Bus Mastering Two High Speed Serial Ports 16550 UART Compatible One Enhanced Parallel Port SPP, EPP, ECP capable One Floppy Drive Port Supports 2 Floppy Drives |
Form Factor | ? |
Power | AT ENERGY SAVING FUNCTIONS |
---
Bios Update |
|||||
Model | File Name | Date | Description | Flasher | Manual |
M507 Small Block Size Bios | 5070311.bin |
11.03.96 |
BIOS for M506/M507 Fixes problem with cache |
Award Flasher v5.2b |
|
M507 Small Block Size Bios | 5070311s.bin |
12.03.96 |
BIOS for M506/M507 PnP-Version, Fixes problem with cache |
Award Flasher v5.2b |
|
M507 Small Block Size Bios | 10.04.97 |
(Bios for the
Amptron PM7600 , Release 04/10/1997S) |
Award Flasher v5.2b |
||
M507 Small Block Size Bios |
*This is an Award BETA Bios : be careful and FLASH AT YOUR RISK !!!! |
10.09.98 | BETA BIOS for M506/M507 This is an Award BETA Bios! Atmel 29C010 works IDT recognized CDRom/LS-Boot Supports HDDs >8.4 GB (up to 32 GB). Linux, NT4 and Win98SE cannot use the 2nd IDE-Port. |
||
M507 Small Block Size Bios |
This is an Award MODIFIED BETA Bios : be careful and FLASH AT YOUR RISK !!!! |
01.03.2000 |
BETA BIOS for M506/M507 This is a modified version of the BETA bios above! Linux and NT can now handle the 2nd IDE-Port Win98SE still has problems with IDE-Ports. You have to remove the IDE-ports, switch in PCI-Bus from hardware to bios detection and excecute a hardware detection. You will now get two IDE/ESDI-ports which are working. |
||
M507 Large Block Size Bios |
N/A |
N/A |
N/A |
N/A |
How to
update Motherboards BIOS PC-CHIPS
1. Check to see what type of flash chip you have
in your Mb. There are two types of flash memory, Large Block and
Small Block. We label them as "L" or "S"
respectively. When you first turn the computer on. The screen
will show the BIOS date code and a letter with "L" or
"S".
2. Down load the right type of BIOS according to what type of
flash chip you got in your MB.
3. Down load the right BIOS flash utilities.
4. Make sure the Voltage on the flash chip were set to 12V on
your Mb
5. Make a clean Bootable Disk that has no config.sys and autoexec.bat
file. Copy BIOS file and Flash Utility to the floppy.
6. Put this bootable diskette in drive A: and boot the system
into A:>
7 Run award or AMI flash utility to flash the bios.
Come aggiornare il bios di una Motherboard PCCHIPS
1. Occorre innanzitutto capire che tipo di flash
eeprom sia installata sulla vostra mainboard. Ci sono due tipi di
memorie flash eeprom, Large Block and Small Block. Noi
indicheremo tali tipi di eeprom rispettivamente con le etichette
"L" o "S" . Quando accendete il vostro pc,
sul monitor apparira' la data di rilascio del BIOS ed una lettera
, che sara' "L" oppure "S": dal tipo di
lettera potete dedurre anche il tipo di flash eeprom installata e
quindi anche il corretto aggiornamento bios da usare.
2. Scaricate l'aggiornamento bios adattoal tipo di flash eeprom
installata sulla vostra MB.
3. Scaricate l'utility corretta per effettuare il flash.
4. Assicuratevi che il voltaggio del bostro chip flash sia
settato a 12V usando l'apposito jumper presente sulla MB
5. Create un disco di Boot privo dei file config.sys ed autoexec.bat.
Copiate il file BIOS e la Flash Utility su tale floppy.
6. Inserite il floppy nel drive A: ed effettuate da esso il boot
7 Eseguite l'utility Award o Ami per flashare il bios.
Flash ROM Voltage and Block Size | |||
TIPO/ Brand |
Voltage |
Block Size |
BIOS file |
MX28F1000PL | 12V | 16K | (xxxxxxx)l.bin |
MX28F1000PC | 12V | 16K | (xxxxxxx)l.bin |
MX28F1000PPC | 12V | 4K | (xxxxxxx)s.bin |
MXIC28F1000AP | 12V | 4K | (xxxxxxx)s.bin |
SST 29EE010 | 5V | 4K | (xxxxxxx)s.bin |
Winbond 29EE011 | 5V | 4K | (xxxxxxx)s.bin |
ATMEL 29C010 | 5V | 4K | (xxxxxxx)s.bin |
Intel 28F001 BX-T120 | 12V | 4K | (xxxxxxx)s.bin |
The difference beetwen Pc Chips M507 (Fugutech M507) and Amptron PM7600
One difference between the Pc Chips M507 mainboard and the Amptron PM7600 mainboard is a different name of multiplier_factor and cpu_speed_selector jumpers. In the PcChips M507 the JP11 and JP12 (cpu speed selectors) jumpers have the same function as the JP8A and JP8B jumpers in the Amptron PM7600; the JP13 and JP14 (internal clock speed selectors) jumpers in the PcChips M507 have the same function as JP9A and JP9B jumpers in the Amptron PM7600.
Using original bios, this mainboard supports up to pentium 133MHz, but, after bios upgrade, it supports up to Pentium 200 MHz. See the new setting scheme :
Differenza tra la Pc Chips M507 (Fugutech M507) e la Amptron PM-7600
Una delle differenze tra la Pc Chips M507 e la Amptron PM7600 consiste in un differente nome del jumper multiplier_factor per settare il fattore di moltiplicazione e del jumper cpu_speed_selector per settare la velocita' della cpu. Nella PcChips M507 i jumper JP11 e JP12 (cpu speed selectors) hanno la stessa funzione del jumper JP8A e JP8B nella Amptron PM7600; i jumper JP13 e JP14 (internal clock speed selectors) nella PcChips M507 hanno la stessa funzione che hanno i jumper JP9A e JP9B nella Amptron PM7600.
Usando il bios originale , tale mainboard supporta correttamente cpu pentium fino a 133MHz, ma effettuando un aggiornamento bios essa supporta Pentium fino a 200 MHz. Fate riferimento al seguente nuovo schema di settaggio
Nuove impostazioni per il Settaggio del
Clock della CPU (per la PcChips M507) |
||||||
CPU_Speed |
JP11 |
JP12 |
CLOCK |
JP13 |
JP14 |
Multiplier |
75MHz |
SHORT |
SHORT |
50MHz |
OPEN |
OPEN |
1.5x |
90MHz |
OPEN | SHORT | 60MHz | OPEN | OPEN |
1.5x |
100MHz | SHORT | OPEN | 66MHz | OPEN | OPEN | 1.5x |
120MHz | OPEN | SHORT | 60MHz | SHORT | OPEN | 2x |
133MHz | SHORT | OPEN | 66MHz | SHORT | OPEN | 2x |
150MHz | OPEN | SHORT | 60MHz | SHORT | SHORT | 2.5x |
166MHz | SHORT | OPEN | 66MHz | SHORT | SHORT | 2.5x |
180MHz | OPEN | SHORT | 60MHz | OPEN | SHORT | 3x |
200MHz | SHORT | OPEN | 66MHz | OPEN | SHORT | 3x |
Nuove impostazioni per il Settaggio del
Clock della CPU ( per la Amptron PM7600 ) |
||||||
CPU_Speed |
JP8A |
JP8B |
CLOCK |
JP9A |
JP9B |
Multiplier |
75MHz |
SHORT |
SHORT |
50MHz |
OPEN |
OPEN |
1.5x |
90MHz |
OPEN | SHORT | 60MHz | OPEN | OPEN |
1.5x |
100MHz | SHORT | OPEN | 66MHz | OPEN | OPEN | 1.5x |
120MHz | OPEN | SHORT | 60MHz | SHORT | OPEN | 2x |
133MHz | SHORT | OPEN | 66MHz | SHORT | OPEN | 2x |
150MHz | OPEN | SHORT | 60MHz | SHORT | SHORT | 2.5x |
166MHz | SHORT | OPEN | 66MHz | SHORT | SHORT | 2.5x |
180MHz | OPEN | SHORT | 60MHz | OPEN | SHORT | 3x |
200MHz | SHORT | OPEN | 66MHz | OPEN | SHORT | 3x |