Pine PT-7502 v.2a

by A.C. (since 23/08/2000) http://acc.hop.to

Avviso

Tutti i marchi citati nel presente archivio appartengono ai rispettivi proprietari.
Tutta la documentazione presente in questo archivio č destinata ad un uso privato e non commerciale.
ATTENZIONE
 Tutte le informazioni di seguito riportate sono da ritenersi NON VERIFICATE : l'autore del presente archivio NON si assume alcuna responsabilitā per danni derivanti direttamente o indirettamente dall'uso delle suddette informazioni
Chiunque decida di usare qualunque risorsa (informazioni, programmi, bios, etc..) presente in questo archivio , lo fa sotto la sua personale responsabilitā !!

Disclaimer
All trademarks used in this private archive are the property of their respective owners.
All documentation in this archive is for private and non-commercial use.
WARNING
 ALL INFORMATION ARE UNTESTED, FLASH AT YOUR RISK!!
I'm NOT RESPONSIBLE for MISTAKES in this archive: BE CAREFUL!!

Direct Analysis
 
Manufacturer Pine
Model PT-7502 v.2a
Subversions  
 
Chipset Intel Triton 430VX
Cpu · Intel i430VX PCIsetTM chipset
· Support either 75/90/100/120/133/166/180/200 MHz PENTIUM TM CPUs with 321 pin ZIF socket
· Support Pentium P55C
· Support Dual Voltage Regulator Module
· Support Cyrix 6x86, AMD K5 CPUs
Cpu Voltage 2.5,2.7, 2.8, 2.9, 3.3, 3.5 V
Bus Clock 50, 55, 60, 66 MHz
Multipliers 1.5x, 2x, 2.5x, 3x
Socket 7
Cache · Support cache module socket, cache module options 256KB or 512KB pipeline burst SRAM module
Bios  
Memory · Uses 72-pin SIMM modules x 4 auto banking in multiple configuration up to 128MB
· Support Both Fast Page Mode and Extended DATA Output (EDO) DRAM module
· Support SDRAM/EDO DRAM/Page Mode DRAM use 168-pin DIMMx2

Note:
1. Bank0 (SIMM1 &SIMM2) and DIM1 the two types DRAM module cannot be used at the same time.
2. Bank0 (SIMM3 & SIMM4) and DIM2 the two types DRAM module cannot be used at the same time.
3.All SIMMs and DIMM module speed must faster than 70ns.
4.All SIMMs and DIMM module can use either 1-sided or 2-sides
5.SIMM socket DRAM type: Fast Page Mode or Extend DATA Out (EDO)
6. DIMM socket DRAM type Fast Page Mode or Extend Data Out (EDO) or synchronous DRAM (SDRAM)
7. Synchronous DRAM (SDRAM JP7) must set to 3.3V position
Dimm 2
Simm 4
Pci slot 4
Isa slot 3
Agp none
PS/2 · Support PS/2 TM connector.
Usb · Support 2 Universal Serial Bus (U.S.B.) (optional)
SCSI NCR810 Support · System BIOS supports NCR810 SCSI BIOS firmware and Green feature function, Plug and Play Flash ROM
I/O · System BIOS support 4 IDE harddisk drivers that don't need device driver for S/W application, the capacity each harddisk can large than 528MB up to 8.4GB
· PCI Bus master IDE interface on board with two connectors support 4 IDE devices in 2 channel, the PCI IDE Controller supports PIO mode 0 to Mode 4 at maximum transfer rate of 16.67 MB/s and Bus master IDE DMA Mode 2.
· On board super Multi-I/O chip that support 2 serial port with 16550 Fast UART compatible, 1 parallel port with SPP, EPP and ECP capabilities, and a floppy disk drive interface.
Onboard Sound none
Built-In Hardware Monitor circuits support thermal none
Form Factor  
Power AT

Bios Update
Subversion File Name Date Description Flasher

Manual
         

Manual