1. The WAN configuration page allow user to set the configuration
for the WAN/ADSL ports.
2. Encapsulation: Choose accordingly to your configuration.
3. ATM
- VPI::
Virtual Path Identifier. Enter the given value by your Internet Service Provider.
- VCI:
Virtual Circuit Identifier. Enter the given value by your Internet Service Provider.
- Service Category:
UBR and CBR are supported from the ATM.
- BandWidth: Bandwidth
setting takes effect only when the CBR is selected. The maximum available
bandwidth is from the upstream data rate of ADSL status page.
4. DHCP Client
- Enable DHCP Client:
Select to enable DHCP Client.
- Host Name:
Enter the Host here.
5. PPP
Note:If user chose
RFC1483 or RFC 1577 configuration please ignore PPP entry.
- Service Name
: The service name of PPP is required by some ISPs. If the ISP does
not provide the Service Name, please leave it blank.
- Username:
If PPP type of encapsulation is setup, you may need to enter the username
given by your Internet Service Provider.
- Password:
If PPP type of encapsulation is setup, you may need to enter the password
given by your Internet Service Provider.
- Disconnect Timeout:
The Disconnect Timeout allows users to set the specific period of time to
disconnect from the ISP. The default is 0, which means never disconnect fro
the ISP.
- Automatic Reconnect:
When it
is checked, it will automatically reconncet ppp session.
- Authentication:
When Auto option is chosen, the PAP mode will run first then Chap.
6. DHCP Client
- Enable DHCP Client:
Select to enable DHCP Client.
- Host Name:
Enter the Host here.